Model name: qDetect LH Test

· Simple one-step ovulation self test
· Result in less than 10min. with urine sample
· Analytical sensitivity: 30mIU/ml
· Storage: 2 – 30℃
· Shelf life: 24 months

IMPORTANT: You may test at any time of a day, but you should test at approximately the same time each day. Continue testing until you have detected your positive results (LH surge).

1. Remove the test stick from a foil pouch just prior to use.
   * NOTE : If the test device has been stored in refrigerator, allow it to warm to room temperature.
2. Remove the cap to expose the absorbent tip.
3. Hold the test device by its thumb grip and point the absorbent tip to downward.
4. Place absorbent tip in urine flow for atleast 05 seconds. It is important to wet enough the absorbent tip.
   * NOTE : Do not urinate on the result window. If you prefer, you can urinate into a clean dry container,
   then dip only the absorbent tip into the urine for at least 05 seconds.
5. To get a correct test result, place the test stick on the level surface with window facing up, you may soon see a red color moving across the result window.(If you wish, replace the cap over the absorbent tip)
6. Wait for 10 minutes and then read the results.

1. Collect urine in clean and dry container.
2. Remove the test stick from foil pouch just prior to use.
   * NOTE : If the test stick has been stored in refrigerator, allow it to warm to room temperature.
3. Remove the cap to expose the absorbent tip.
4. Hold the test stick tightly and dip the absorbent tip into the urine specimen for 3-5 seconds.
5. Remove the test stick from the urine specimen and place it on the flat surface.
   And you may see moving red color on the result window.
6. Wait for 10 minutes and read the result.

1. Bring all materials and specimen to room temperature,
   and then open the foil pouch and place the device on a clean, dry and level surface.
   * NOTE :Once the foil pouch is opened, the device should be used as soon as possible.
2. Use the disposable pipette to deliver 4 full drops (0.2ml) of urine into the sample well.
   The test device should not be handled or moved until the test is complete and ready for reading.
   * NOTE : Do not drop the urine into window.
3. Wait for 10 minutes and then read the results.
   * NOTE : Do not interpret results after 30 minutes, because it may affect the result.

Result Interpretation

Order Information